Petrol

Audi A6 4Gx 2011 onwards 2.0 TFSI remap

Standard this engine makes 180hp and 320Nm. Our STAGE 1 file takes it to 260hp and 420Nm.

+80horsepower
+100newton metres
2stages available

Where the power arrives

Power and torque through the rev range, on the STAGE 1 file.

Power before and after
0701402112811,0001,7752,5503,3254,1004,875 RPM 0701402112811,0002,2503,4754,725hp RPM
  • Standard 180hp
  • Remapped 260hp
Torque before and after
01132273404541,0001,7752,5503,3254,1004,875 RPM 01132273404541,0002,2503,4754,725Nm RPM
  • Standard 320Nm
  • Remapped 420Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 2.0 TFSI

FilePowerGainTorqueGainPrice
Standard180hpn/a320Nmn/an/a
ECOn/an/a420Nmup 100£520
STAGE 1260hpup 80420Nmup 100£620

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 2.0 TFSI

The Audi A6 4Gx 2011 onwards 2.0 TFSI runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 4Gx 2011 onwards, the full A6 range, or everything we do for Audi.

Book your A6

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.