Audi Q2 2016 onwards 1.4 TDI remap
Standard this engine makes 90hp and 230Nm. Our Stage 1 file takes it to 115hp and 280Nm.
Where the power arrives
Power and torque through the rev range, on the Stage 1 file.
- Standard 90hp
- Remapped 115hp
- Standard 230Nm
- Remapped 280Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Every figure for the 1.4 TDI
| File | Power | Gain | Torque | Gain | Price |
|---|---|---|---|---|---|
| Standard | 90hp | n/a | 230Nm | n/a | n/a |
| Stage 1 | 115hp | up 25 | 280Nm | up 50 | ask us |
Economy files show no new power figure because they are written for torque and drivability rather than peak output.
Remapping the 1.4 TDI
The Audi Q2 2016 onwards 1.4 TDI runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
Diesels like this one gain most through the middle of the rev range, which is where you actually drive. It pulls from lower down, holds a gear on a hill, and needs fewer downshifts to overtake. Drive it the same way afterwards and the economy usually improves a little.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 2016 onwards, the full Q2 range, or everything we do for Audi.
Similar power, other makes
Cars running about the same standard output, for comparison.
Other Q2 generations
Book your Q2
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.