Audi S4 B8 2008 to 2015 S4 - 3.0 TFSi remap
Standard this engine makes 354hp and 500Nm. Our Stage 1 file takes it to 354hp and 500Nm.
Where the power arrives
Power and torque through the rev range, on the Stage 1 file.
- Standard 354hp
- Remapped 354hp
- Standard 500Nm
- Remapped 500Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Every figure for the S4 - 3.0 TFSi
| File | Power | Gain | Torque | Gain | Price |
|---|---|---|---|---|---|
| Standard | 354hp | n/a | 500Nm | n/a | n/a |
| Stage 1 | 354hp | n/a | 500Nm | n/a | ask us |
Economy files show no new power figure because they are written for torque and drivability rather than peak output.
Remapping the S4 - 3.0 TFSi
The Audi S4 B8 2008 to 2015 S4 - 3.0 TFSi runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the B8 2008 to 2015, the full S4 range, or everything we do for Audi.
Other engines on this S4
B8 2008 to 2015 cars.
Similar power, other makes
Cars running about the same standard output, for comparison.
Other S4 generations
Book your S4
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.