BMW 3 GT-Series F34 2012 to 2016 330d remap
Standard this engine makes 258hp and 560Nm. Our STAGE 2 file takes it to 330hp and 680Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 2 file.
- Standard 258hp
- Remapped 330hp
- Standard 560Nm
- Remapped 680Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 330d
The BMW 3 GT-Series F34 2012 to 2016 330d runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
Diesels like this one gain most through the middle of the rev range, which is where you actually drive. It pulls from lower down, holds a gear on a hill, and needs fewer downshifts to overtake. Drive it the same way afterwards and the economy usually improves a little.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the F34 2012 to 2016, the full 3 GT-Series range, or everything we do for BMW.
Other engines on this 3 GT-Series
F34 2012 to 2016 cars.
Similar power, other makes
Cars running about the same standard output, for comparison.
Other 3 GT-Series generations
Book your 3 GT-Series
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.