BMW M3 F80 2011 onwards M3 CS remap
Standard this engine makes 460hp and 600Nm. Our STAGE 3 file takes it to 575hp and 780Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 3 file.
- Standard 460hp
- Remapped 575hp
- Standard 600Nm
- Remapped 780Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Every figure for the M3 CS
| File | Power | Gain | Torque | Gain | Price |
|---|---|---|---|---|---|
| Standard | 460hp | n/a | 600Nm | n/a | n/a |
| ECO | n/a | n/a | 680Nm | up 80 | £890 |
| STAGE 1 | 500hp | up 40 | 680Nm | up 80 | £990 |
| STAGE 2 | 520hp | up 60 | 720Nm | up 120 | £1,238 |
| STAGE 3 | 575hp | up 115 | 780Nm | up 180 | £1,485 |
Economy files show no new power figure because they are written for torque and drivability rather than peak output.
Remapping the M3 CS
The BMW M3 F80 2011 onwards M3 CS runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the F80 2011 onwards, the full M3 range, or everything we do for BMW.
Other engines on this M3
F80 2011 onwards cars.
Similar power, other makes
Cars running about the same standard output, for comparison.
Other M3 generations
Book your M3
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.