BMW X6 E71 2008 to 2014 X Drive 30d remap
Standard this engine makes 211hp and 520Nm. Our STAGE 1 file takes it to 280hp and 600Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 211hp
- Remapped 280hp
- Standard 520Nm
- Remapped 600Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the X Drive 30d
The BMW X6 E71 2008 to 2014 X Drive 30d runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
Diesels like this one gain most through the middle of the rev range, which is where you actually drive. It pulls from lower down, holds a gear on a hill, and needs fewer downshifts to overtake. Drive it the same way afterwards and the economy usually improves a little.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the E71 2008 to 2014, the full X6 range, or everything we do for BMW.
Other engines on this X6
E71 2008 to 2014 cars.
- X Drive 30d (May 2010)211hp standardDiesel
- X Drive 30d235hp standardDiesel
- X Drive 30d 245hp standardDiesel
- X Drive 35d286hp standardDiesel
- X Drive 40d306hp standardDiesel
- X Drive 35i306hp standardPetrol
- M - 50d381hp standardPetrol
- X Drive 50i407hp standardPetrol
- X Drive 50i ActiveHybrid486hp standardPetrol
- M555hp standardPetrol
Similar power, other makes
Cars running about the same standard output, for comparison.
Other X6 generations
Book your X6
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.