Petrol

BMW Z4 E85 2007 onwards 2.5i remap

Standard this engine makes 192hp and 245Nm. Our STAGE 1 file takes it to 210hp and 260Nm.

+18horsepower
+15newton metres
2stages available

Where the power arrives

Power and torque through the rev range, on the STAGE 1 file.

Power before and after
0571131702271,0002,0753,1504,2255,2756,350 RPM 0571131702271,0002,7254,4256,150hp RPM
  • Standard 192hp
  • Remapped 210hp
Torque before and after
0701402112811,0002,0753,1504,2255,2756,350 RPM 0701402112811,0002,7254,4256,150Nm RPM
  • Standard 245Nm
  • Remapped 260Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 2.5i

FilePowerGainTorqueGainPrice
Standard192hpn/a245Nmn/an/a
ECOn/an/a260Nmup 15£470
STAGE 1210hpup 18260Nmup 15£570

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 2.5i

The BMW Z4 E85 2007 onwards 2.5i runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the E85 2007 onwards, the full Z4 range, or everything we do for BMW.

Other Z4 generations

Book your Z4

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.