Engine

Caterpillar 3406E All years 14.6 441hp (324kW) 2380Nm remap

Standard this engine makes 441hp and 2380Nm. Our Stage 1 file takes it to 558hp and 2642Nm.

+117horsepower

+262newton metres

1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after

Standard 441hp
Remapped 558hp

Torque before and after

Standard 2380Nm
Remapped 2642Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Stage 1558hpup 1172642Nmup 262

Every figure for the 14.6 441hp (324kW) 2380Nm

File	Power	Gain	Torque	Gain	Price
Standard	441hp	n/a	2380Nm	n/a	n/a
Stage 1	558hp	up 117	2642Nm	up 262	ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 14.6 441hp (324kW) 2380Nm

The Caterpillar 3406E All years 14.6 441hp (324kW) 2380Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full 3406E range, or everything we do for Caterpillar.

Other engines on this 3406E

All years cars.

Book your 3406E

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.

Call 0121 238 8663 Ask a question