Dacia Dokker 2017 onwards 1.5 DCI remap
Standard this engine makes 75hp and 200Nm. Our STAGE 1 file takes it to 115hp and 260Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 75hp
- Remapped 115hp
- Standard 200Nm
- Remapped 260Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 1.5 DCI
The Dacia Dokker 2017 onwards 1.5 DCI runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 2017 onwards, the full Dokker range, or everything we do for Dacia.
Other engines on this Dokker
2017 onwards cars.
Other Dokker generations
Book your Dokker
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.