Dacia Duster 2018 onwards 1.5 DCI remap
Standard this engine makes 110hp and 260Nm. Our STAGE 1 file takes it to 135hp and 310Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 110hp
- Remapped 135hp
- Standard 260Nm
- Remapped 310Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 1.5 DCI
The Dacia Duster 2018 onwards 1.5 DCI runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 2018 onwards, the full Duster range, or everything we do for Dacia.
Other engines on this Duster
2018 onwards cars.
Other Duster generations
Book your Duster
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.