Engine

Deutz Agrotron All years M410 6.0 R6 134hp (99kW) 610Nm remap

Standard this engine makes 134hp and 610Nm. Our Stage 1 file takes it to 156hp and 695Nm.

+22horsepower

+85newton metres

1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after

Standard 134hp
Remapped 156hp

Torque before and after

Standard 610Nm
Remapped 695Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Stage 1156hpup 22695Nmup 85

Every figure for the M410 6.0 R6 134hp (99kW) 610Nm

File	Power	Gain	Torque	Gain	Price
Standard	134hp	n/a	610Nm	n/a	n/a
Stage 1	156hp	up 22	695Nm	up 85	ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the M410 6.0 R6 134hp (99kW) 610Nm

The Deutz Agrotron All years M410 6.0 R6 134hp (99kW) 610Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Agrotron range, or everything we do for Deutz.

Other engines on this Agrotron

All years cars.

Book your Agrotron

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.

Call 0121 238 8663 Ask a question