DS DS3 2009 to 2016 1.6 THP remap
Standard this engine makes 150hp and 240Nm. Our STAGE 2 file takes it to 205hp and 320Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 2 file.
- Standard 150hp
- Remapped 205hp
- Standard 240Nm
- Remapped 320Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 1.6 THP
The DS DS3 2009 to 2016 1.6 THP runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 2009 to 2016, the full DS3 range, or everything we do for DS.
Other engines on this DS3
2009 to 2016 cars.
- 1.4 HDi68hp standardDiesel
- 1.6 HDi90hp standardDiesel
- 1.6 e-HDI92hp standardDiesel
- 1.6 BlueHDi100hp standardDiesel
- 1.6 HDi112hp standardDiesel
- 1.6 e-HDi115hp standardDiesel
- 1.6 BlueHDi120hp standardDiesel
- 1.2 PureTech82hp standardPetrol
- 1.2 Puretech110hp standardPetrol
- 1.6 VTi120hp standardPetrol
- 1.6 THP156hp standardPetrol
- 1.6 THP165hp standardPetrol
- 1.6 THP202hp standardPetrol
Similar power, other makes
Cars running about the same standard output, for comparison.
Other DS3 generations
Book your DS3
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.