Engine

Fendt 400 serie All years 409 Vario 86hp (63kW) 415Nm remap

Standard this engine makes 86hp and 415Nm. Our Stage 1 file takes it to 110hp and 500Nm.

+24horsepower
+85newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
030598911901,2001,6002,0002,400 RPM 030598911901,4002,0002,600hp RPM
  • Standard 86hp
  • Remapped 110hp
Torque before and after
013527040554001,2001,6002,0002,400 RPM 013527040554001,4002,0002,600Nm RPM
  • Standard 415Nm
  • Remapped 500Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 409 Vario 86hp (63kW) 415Nm

FilePowerGainTorqueGainPrice
Standard86hpn/a415Nmn/an/a
Stage 1110hpup 24500Nmup 85ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 409 Vario 86hp (63kW) 415Nm

The Fendt 400 serie All years 409 Vario 86hp (63kW) 415Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full 400 serie range, or everything we do for Fendt.

Book your 400 serie

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.