Fiat Punto EVO 2010 onwards 1.4 T Abarth remap
Standard this engine makes 163hp and 250Nm. Our STAGE 2 file takes it to 200hp and 320Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 2 file.
- Standard 163hp
- Remapped 200hp
- Standard 250Nm
- Remapped 320Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 1.4 T Abarth
The Fiat Punto EVO 2010 onwards 1.4 T Abarth runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 2010 onwards, the full Punto EVO range, or everything we do for Fiat.
Other engines on this Punto EVO
2010 onwards cars.
- 1.3 Mjet70hp standardDiesel
- 1.3 Mjet85hp standardDiesel
- 1.3 Mjet95hp standardDiesel
- 1.6 Mjet120hp standardDiesel
- 1.2 8V69hp standardPetrol
- 1.4 8V77hp standardPetrol
- 1.4 Multiair135hp standardPetrol
- 1.4 T Abarth EsseEsse180hp standardPetrol
- 1.4 T Abarth Scorpione180hp standardPetrol
- 1.4 T Abarth Supersport180hp standardPetrol
Similar power, other makes
Cars running about the same standard output, for comparison.
Book your Punto EVO
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.