Ford Fiesta Mk5 2003 to 2008 2.0i ST remap
Standard this engine makes 150hp and 190Nm. Our STAGE 2 file takes it to 175hp and 212Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 2 file.
- Standard 150hp
- Remapped 175hp
- Standard 190Nm
- Remapped 212Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 2.0i ST
The Ford Fiesta Mk5 2003 to 2008 2.0i ST runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the Mk5 2003 to 2008, the full Fiesta range, or everything we do for Ford.
Other engines on this Fiesta
Mk5 2003 to 2008 cars.
Similar power, other makes
Cars running about the same standard output, for comparison.
Other Fiesta generations
Book your Fiesta
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.