Hyundai i 30 2017 onwards 2.0 T 'N' remap
Standard this engine makes 250hp and 353Nm. Our STAGE 2 file takes it to 320hp and 460Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 2 file.
- Standard 250hp
- Remapped 320hp
- Standard 353Nm
- Remapped 460Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 2.0 T 'N'
The Hyundai i 30 2017 onwards 2.0 T 'N' runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 2017 onwards, the full i 30 range, or everything we do for Hyundai.
Other engines on this i 30
2017 onwards cars.
Similar power, other makes
Cars running about the same standard output, for comparison.
Other i 30 generations
Book your i 30
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.