Engine

Iveco EuroStar All years E52 520hp (382kW) 2300Nm remap

Standard this engine makes 520hp and 2300Nm. Our Stage 1 file takes it to 590hp and 2635Nm.

+70horsepower
+335newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
015931947863701,5002,5003,5004,500 RPM 015931947863702,0003,5005,000hp RPM
  • Standard 520hp
  • Remapped 590hp
Torque before and after
071114232134284601,5002,5003,5004,500 RPM 071114232134284602,0003,5005,000Nm RPM
  • Standard 2300Nm
  • Remapped 2635Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the E52 520hp (382kW) 2300Nm

FilePowerGainTorqueGainPrice
Standard520hpn/a2300Nmn/an/a
Stage 1590hpup 702635Nmup 335ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the E52 520hp (382kW) 2300Nm

The Iveco EuroStar All years E52 520hp (382kW) 2300Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full EuroStar range, or everything we do for Iveco.

Book your EuroStar

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.