Iveco EuroTech All years E35 350hp (257kW) 1280Nm remap
Standard this engine makes 350hp and 1280Nm. Our Stage 1 file takes it to 400hp and 1460Nm.
Where the power arrives
Both curves scaled from the manufacturer figures, on the Stage 1 file.
- Standard 350hp
- Remapped 400hp
- Standard 1280Nm
- Remapped 1460Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Every figure for the E35 350hp (257kW) 1280Nm
| File | Power | Gain | Torque | Gain | Price |
|---|---|---|---|---|---|
| Standard | 350hp | n/a | 1280Nm | n/a | n/a |
| Stage 1 | 400hp | up 50 | 1460Nm | up 180 | ask us |
Economy files show no new power figure because they are written for torque and drivability rather than peak output.
Remapping the E35 350hp (257kW) 1280Nm
The Iveco EuroTech All years E35 350hp (257kW) 1280Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full EuroTech range, or everything we do for Iveco.
Other engines on this EuroTech
All years cars.
Book your EuroTech
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.