Engine

Iveco Trakker All years T50 500hp (368kW) 2300Nm remap

Standard this engine makes 500hp and 2300Nm. Our Stage 1 file takes it to 568hp and 2638Nm.

+68horsepower
+338newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
015330746061301,5002,5003,5004,500 RPM 015330746061302,0003,5005,000hp RPM
  • Standard 500hp
  • Remapped 568hp
Torque before and after
071214252137284901,5002,5003,5004,500 RPM 071214252137284902,0003,5005,000Nm RPM
  • Standard 2300Nm
  • Remapped 2638Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the T50 500hp (368kW) 2300Nm

FilePowerGainTorqueGainPrice
Standard500hpn/a2300Nmn/an/a
Stage 1568hpup 682638Nmup 338ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the T50 500hp (368kW) 2300Nm

The Iveco Trakker All years T50 500hp (368kW) 2300Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Trakker range, or everything we do for Iveco.

Book your Trakker

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.