Engine

JCB Fastrac All years 3200 194hp (143kW) 760Nm remap

Standard this engine makes 194hp and 760Nm. Our Stage 1 file takes it to 238hp and 935Nm.

+44horsepower
+175newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
06412919325701,2001,6002,0002,400 RPM 06412919325701,4002,0002,600hp RPM
  • Standard 194hp
  • Remapped 238hp
Torque before and after
0252505757101001,2001,6002,0002,400 RPM 0252505757101001,4002,0002,600Nm RPM
  • Standard 760Nm
  • Remapped 935Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 3200 194hp (143kW) 760Nm

FilePowerGainTorqueGainPrice
Standard194hpn/a760Nmn/an/a
Stage 1238hpup 44935Nmup 175ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 3200 194hp (143kW) 760Nm

The JCB Fastrac All years 3200 194hp (143kW) 760Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Fastrac range, or everything we do for JCB.

Book your Fastrac

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.