Mazda CX-7 All years 2.2 CDVi remap
Standard this engine makes 173hp and 400Nm. Our STAGE 1 file takes it to 205hp and 460Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 173hp
- Remapped 205hp
- Standard 400Nm
- Remapped 460Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 2.2 CDVi
The Mazda CX-7 All years 2.2 CDVi runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
Diesels like this one gain most through the middle of the rev range, which is where you actually drive. It pulls from lower down, holds a gear on a hill, and needs fewer downshifts to overtake. Drive it the same way afterwards and the economy usually improves a little.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full CX-7 range, or everything we do for Mazda.
Other engines on this CX-7
All years cars.
Similar power, other makes
Cars running about the same standard output, for comparison.
Book your CX-7
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.