Mercedes Maybach 2016 onwards 3.0 V6 Twin-Turbo Plug-In Hybrid remap
Standard this engine makes 436hp and 650Nm. Our STAGE 1 file takes it to 500hp and 850Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 436hp
- Remapped 500hp
- Standard 650Nm
- Remapped 850Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 3.0 V6 Twin-Turbo Plug-In Hybrid
The Mercedes Maybach 2016 onwards 3.0 V6 Twin-Turbo Plug-In Hybrid runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 2016 onwards, the full Maybach range, or everything we do for Mercedes.
Other engines on this Maybach
2016 onwards cars.
Book your Maybach
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.