Mitsubishi EVO All years Evo IX remap
Standard this engine makes 280hp and 355Nm. Our STAGE 2 file takes it to 370hp and 500Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 2 file.
- Standard 280hp
- Remapped 370hp
- Standard 355Nm
- Remapped 500Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the Evo IX
The Mitsubishi EVO All years Evo IX runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full EVO range, or everything we do for Mitsubishi.
Other engines on this EVO
All years cars.
Similar power, other makes
Cars running about the same standard output, for comparison.
Book your EVO
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.