Opel Corsa D 2006 to 2014 OPC 1.6T remap
Standard this engine makes 192hp and 230Nm. Our STAGE 2 file takes it to 230hp and 350Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 2 file.
- Standard 192hp
- Remapped 230hp
- Standard 230Nm
- Remapped 350Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the OPC 1.6T
The Opel Corsa D 2006 to 2014 OPC 1.6T runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the D 2006 to 2014, the full Corsa range, or everything we do for Opel.
Other engines on this Corsa
D 2006 to 2014 cars.
- 1.3 CDTI75hp standardDiesel
- 1.3 CDTI90hp standardDiesel
- 1.3 CDTI Ecotec95hp standardDiesel
- 1.7 CDTI100hp standardDiesel
- 1.7 CDTI125hp standardDiesel
- 1.7 CDTI130hp standardDiesel
- 1.486hp standardPetrol
- 1.4 16v100hp standardPetrol
- 1.4T120hp standardPetrol
- GSI 1.6T150hp standardPetrol
- OPC 1.6T Nürburgring210hp standardPetrol
Similar power, other makes
Cars running about the same standard output, for comparison.
Other Corsa generations
Book your Corsa
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.