Opel Sintra All years 2.2 DTI remap
Standard this engine makes 114hp and 260Nm. Our Stage 1 file takes it to 140hp and 330Nm.
Where the power arrives
Power and torque through the rev range, on the Stage 1 file.
- Standard 114hp
- Remapped 140hp
- Standard 260Nm
- Remapped 330Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Every figure for the 2.2 DTI
| File | Power | Gain | Torque | Gain | Price |
|---|---|---|---|---|---|
| Standard | 114hp | n/a | 260Nm | n/a | n/a |
| Stage 1 | 140hp | up 26 | 330Nm | up 70 | ask us |
Economy files show no new power figure because they are written for torque and drivability rather than peak output.
Remapping the 2.2 DTI
The Opel Sintra All years 2.2 DTI runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
Diesels like this one gain most through the middle of the rev range, which is where you actually drive. It pulls from lower down, holds a gear on a hill, and needs fewer downshifts to overtake. Drive it the same way afterwards and the economy usually improves a little.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Sintra range, or everything we do for Opel.
Similar power, other makes
Cars running about the same standard output, for comparison.
Book your Sintra
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.