Renault Megane Megane 3 (ph1) 2008 to 2012 2.0 TCE remap
Standard this engine makes 180hp and 300Nm. Our STAGE 1 file takes it to 210hp and 360Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 180hp
- Remapped 210hp
- Standard 300Nm
- Remapped 360Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 2.0 TCE
The Renault Megane Megane 3 (ph1) 2008 to 2012 2.0 TCE runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the Megane 3 (ph1) 2008 to 2012, the full Megane range, or everything we do for Renault.
Other engines on this Megane
Megane 3 (ph1) 2008 to 2012 cars.
- 1.5 DCi85hp standardDiesel
- 1.5 DCi90hp standardDiesel
- 1.5 DCi105hp standardDiesel
- 1.5 DCi110hp standardDiesel
- 1.6 DCi130hp standardDiesel
- 1.9 DCi130hp standardDiesel
- 2.0 DCi150hp standardDiesel
- 2.0 DCi160hp standardDiesel
- 1.4 TCE130hp standardPetrol
- 2.0T GT220hp standardPetrol
- RS 2.0T250hp standardPetrol
- RS Trophy265hp standardPetrol
Similar power, other makes
Cars running about the same standard output, for comparison.
Other Megane generations
Book your Megane
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.