Scania P-series All years 310 310hp (228kW) 1550Nm remap
Standard this engine makes 310hp and 1550Nm. Our Stage 1 file takes it to 355hp and 1785Nm.
Where the power arrives
Both curves scaled from the manufacturer figures, on the Stage 1 file.
- Standard 310hp
- Remapped 355hp
- Standard 1550Nm
- Remapped 1785Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Every figure for the 310 310hp (228kW) 1550Nm
| File | Power | Gain | Torque | Gain | Price |
|---|---|---|---|---|---|
| Standard | 310hp | n/a | 1550Nm | n/a | n/a |
| Stage 1 | 355hp | up 45 | 1785Nm | up 235 | ask us |
Economy files show no new power figure because they are written for torque and drivability rather than peak output.
Remapping the 310 310hp (228kW) 1550Nm
The Scania P-series All years 310 310hp (228kW) 1550Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full P-series range, or everything we do for Scania.
Book your P-series
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.