Seat Altea 2004 onwards 2.0 TFSi remap
Standard this engine makes 200hp and 280Nm. Our STAGE 1 file takes it to 240hp and 360Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 200hp
- Remapped 240hp
- Standard 280Nm
- Remapped 360Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 2.0 TFSi
The Seat Altea 2004 onwards 2.0 TFSi runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 2004 onwards, the full Altea range, or everything we do for Seat.
Other engines on this Altea
2004 onwards cars.
- 1.6 TDi90hp standardDiesel
- 1.6 TDi105hp standardDiesel
- 1.9 TDi105hp standardDiesel
- 2.0 TDi (IP)136hp standardDiesel
- 2.0 TDi (CR)140hp standardDiesel
- 2.0 TDi (IP)140hp standardDiesel
- 2.0 TDi (CR)170hp standardDiesel
- 2.0 TDi (PPD)170hp standardDiesel
- 1.2 TSi105hp standardPetrol
- 1.4 TSi125hp standardPetrol
- 1.8 TSi160hp standardPetrol
Similar power, other makes
Cars running about the same standard output, for comparison.
Book your Altea
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.