Seat Leon 5F Mk2 2017 onwards 1.6 TDI remap
Standard this engine makes 116hp and 250Nm. Our STAGE 1 file takes it to 140hp and 310Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 116hp
- Remapped 140hp
- Standard 250Nm
- Remapped 310Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 1.6 TDI
The Seat Leon 5F Mk2 2017 onwards 1.6 TDI runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
Diesels like this one gain most through the middle of the rev range, which is where you actually drive. It pulls from lower down, holds a gear on a hill, and needs fewer downshifts to overtake. Drive it the same way afterwards and the economy usually improves a little.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 5F Mk2 2017 onwards, the full Leon range, or everything we do for Seat.
Other engines on this Leon
5F Mk2 2017 onwards cars.
- 2.0 TDI150hp standardDiesel
- 2.0 TDI184hp standardDiesel
- 1.2 TSI110hp standardPetrol
- 1.4 TGI110hp standardPetrol
- 1.0 TSI115hp standardPetrol
- 1.4 TSI150hp standardPetrol
- 1.8 TSI180hp standardPetrol
- 2.0 TSI190hp standardPetrol
- 2.0 TSI Cupra (GPF)290hp standardPetrol
- 2.0 TSI Cupra300hp standardPetrol
- 2.0 TSI Cupra R310hp standardPetrol
Similar power, other makes
Cars running about the same standard output, for comparison.
Other Leon generations
Book your Leon
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.