Steyr 4000serie All years 4120 121hp (89kW) 563Nm remap
Standard this engine makes 121hp and 563Nm. Our Stage 1 file takes it to 138hp and 616Nm.
Where the power arrives
Both curves scaled from the manufacturer figures, on the Stage 1 file.
- Standard 121hp
- Remapped 138hp
- Standard 563Nm
- Remapped 616Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Every figure for the 4120 121hp (89kW) 563Nm
| File | Power | Gain | Torque | Gain | Price |
|---|---|---|---|---|---|
| Standard | 121hp | n/a | 563Nm | n/a | n/a |
| Stage 1 | 138hp | up 17 | 616Nm | up 53 | ask us |
Economy files show no new power figure because they are written for torque and drivability rather than peak output.
Remapping the 4120 121hp (89kW) 563Nm
The Steyr 4000serie All years 4120 121hp (89kW) 563Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full 4000serie range, or everything we do for Steyr.
Other engines on this 4000serie
All years cars.
Book your 4000serie
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.