Petrol

Audi A7 4GA 2010 onwards 3.0 TFSi remap

Standard this engine makes 333hp and 440Nm. Our STAGE 2 file takes it to 430hp and 550Nm.

+97horsepower

+110newton metres

3stages available

Where the power arrives

Power and torque through the rev range, on the STAGE 2 file.

Power before and after

Standard 333hp
Remapped 430hp

Torque before and after

Standard 440Nm
Remapped 550Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 3.0 TFSi

File	Power	Gain	Torque	Gain	Price
Standard	333hp	n/a	440Nm	n/a	n/a
ECO	n/a	n/a	520Nm	up 80	£790
STAGE 1	400hp	up 67	520Nm	up 80	£890
STAGE 2	430hp	up 97	550Nm	up 110	£1,112

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 3.0 TFSi

The Audi A7 4GA 2010 onwards 3.0 TFSi runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 4GA 2010 onwards, the full A7 range, or everything we do for Audi.

Other engines on this A7

4GA 2010 onwards cars.

Similar power, other makes

Cars running about the same standard output, for comparison.

Book your A7

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.

Call 0121 238 8663 Ask a question