Audi S5 2007 onwards S5 3.0 TFSi remap
Standard this engine makes 333hp and 440Nm. Our STAGE 2 file takes it to 430hp and 550Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 2 file.
- Standard 333hp
- Remapped 430hp
- Standard 440Nm
- Remapped 550Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the S5 3.0 TFSi
The Audi S5 2007 onwards S5 3.0 TFSi runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 2007 onwards, the full S5 range, or everything we do for Audi.
Other engines on this S5
2007 onwards cars.
Similar power, other makes
Cars running about the same standard output, for comparison.
Other S5 generations
Book your S5
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.