Engine

Case CVX All years 160 160hp (118kW) 675Nm remap

Standard this engine makes 160hp and 675Nm. Our Stage 1 file takes it to 198hp and 836Nm.

+38horsepower
+161newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
05310716021401,5002,5003,5004,500 RPM 05310716021402,0003,5005,000hp RPM
  • Standard 160hp
  • Remapped 198hp
Torque before and after
022645167790301,5002,5003,5004,500 RPM 022645167790302,0003,5005,000Nm RPM
  • Standard 675Nm
  • Remapped 836Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 160 160hp (118kW) 675Nm

FilePowerGainTorqueGainPrice
Standard160hpn/a675Nmn/an/a
Stage 1198hpup 38836Nmup 161ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 160 160hp (118kW) 675Nm

The Case CVX All years 160 160hp (118kW) 675Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full CVX range, or everything we do for Case.

Book your CVX

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.