Engine

Caterpillar C13 All years 12.5 385hp (283kW) 1966Nm remap

Standard this engine makes 385hp and 1966Nm. Our Stage 1 file takes it to 442hp and 2246Nm.

+57horsepower
+280newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
011923935847701,2001,6002,0002,400 RPM 011923935847701,4002,0002,600hp RPM
  • Standard 385hp
  • Remapped 442hp
Torque before and after
060612131819242601,2001,6002,0002,400 RPM 060612131819242601,4002,0002,600Nm RPM
  • Standard 1966Nm
  • Remapped 2246Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 12.5 385hp (283kW) 1966Nm

FilePowerGainTorqueGainPrice
Standard385hpn/a1966Nmn/an/a
Stage 1442hpup 572246Nmup 280ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 12.5 385hp (283kW) 1966Nm

The Caterpillar C13 All years 12.5 385hp (283kW) 1966Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full C13 range, or everything we do for Caterpillar.

Book your C13

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.