Engine

Claas Arion All years 410 4.5L 95hp (70kW) 420Nm remap

Standard this engine makes 95hp and 420Nm. Our Stage 1 file takes it to 115hp and 524Nm.

+20horsepower
+104newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
031629312401,2001,6002,0002,400 RPM 031629312401,4002,0002,600hp RPM
  • Standard 95hp
  • Remapped 115hp
Torque before and after
014128342456601,2001,6002,0002,400 RPM 014128342456601,4002,0002,600Nm RPM
  • Standard 420Nm
  • Remapped 524Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 410 4.5L 95hp (70kW) 420Nm

FilePowerGainTorqueGainPrice
Standard95hpn/a420Nmn/an/a
Stage 1115hpup 20524Nmup 104ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 410 4.5L 95hp (70kW) 420Nm

The Claas Arion All years 410 4.5L 95hp (70kW) 420Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Arion range, or everything we do for Claas.

Book your Arion

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.