Engine

Claas Arion All years 610 6.8 R6 120hp (88kW) 580Nm remap

Standard this engine makes 120hp and 580Nm. Our Stage 1 file takes it to 150hp and 725Nm.

+30horsepower
+145newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
0418112216201,2001,6002,0002,400 RPM 0418112216201,4002,0002,600hp RPM
  • Standard 120hp
  • Remapped 150hp
Torque before and after
019639258778301,2001,6002,0002,400 RPM 019639258778301,4002,0002,600Nm RPM
  • Standard 580Nm
  • Remapped 725Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 610 6.8 R6 120hp (88kW) 580Nm

FilePowerGainTorqueGainPrice
Standard120hpn/a580Nmn/an/a
Stage 1150hpup 30725Nmup 145ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 610 6.8 R6 120hp (88kW) 580Nm

The Claas Arion All years 610 6.8 R6 120hp (88kW) 580Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Arion range, or everything we do for Claas.

Book your Arion

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.