Engine

DAF CF65 All years GR210 6.7L 286hp (210kW) 1020Nm remap

Standard this engine makes 286hp and 1020Nm. Our Stage 1 file takes it to 325hp and 1170Nm.

+39horsepower
+150newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
08817626335101,2001,6002,0002,400 RPM 08817626335101,4002,0002,600hp RPM
  • Standard 286hp
  • Remapped 325hp
Torque before and after
0316632948126401,2001,6002,0002,400 RPM 0316632948126401,4002,0002,600Nm RPM
  • Standard 1020Nm
  • Remapped 1170Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the GR210 6.7L 286hp (210kW) 1020Nm

FilePowerGainTorqueGainPrice
Standard286hpn/a1020Nmn/an/a
Stage 1325hpup 391170Nmup 150ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the GR210 6.7L 286hp (210kW) 1020Nm

The DAF CF65 All years GR210 6.7L 286hp (210kW) 1020Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full CF65 range, or everything we do for DAF.

Book your CF65

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.