DAF XE All years 315C 12.6L 428hp (315kW) 1950Nm remap
Standard this engine makes 428hp and 1950Nm. Our Stage 1 file takes it to 495hp and 2200Nm.
Where the power arrives
Both curves scaled from the manufacturer figures, on the Stage 1 file.
- Standard 428hp
- Remapped 495hp
- Standard 1950Nm
- Remapped 2200Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Every figure for the 315C 12.6L 428hp (315kW) 1950Nm
| File | Power | Gain | Torque | Gain | Price |
|---|---|---|---|---|---|
| Standard | 428hp | n/a | 1950Nm | n/a | n/a |
| Stage 1 | 495hp | up 67 | 2200Nm | up 250 | ask us |
Economy files show no new power figure because they are written for torque and drivability rather than peak output.
Remapping the 315C 12.6L 428hp (315kW) 1950Nm
The DAF XE All years 315C 12.6L 428hp (315kW) 1950Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full XE range, or everything we do for DAF.
Other engines on this XE
All years cars.
Book your XE
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.