Engine

Iveco Daily All years 2.3 JTD 96hp (71kW) 240Nm remap

Standard this engine makes 96hp and 240Nm. Our Stage 1 file takes it to 120hp and 268Nm.

+24horsepower
+28newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
032659713001,5002,5003,5004,500 RPM 032659713002,0003,5005,000hp RPM
  • Standard 96hp
  • Remapped 120hp
Torque before and after
07214521728901,5002,5003,5004,500 RPM 07214521728902,0003,5005,000Nm RPM
  • Standard 240Nm
  • Remapped 268Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 2.3 JTD 96hp (71kW) 240Nm

FilePowerGainTorqueGainPrice
Standard96hpn/a240Nmn/an/a
Stage 1120hpup 24268Nmup 28ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 2.3 JTD 96hp (71kW) 240Nm

The Iveco Daily All years 2.3 JTD 96hp (71kW) 240Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Daily range, or everything we do for Iveco.

Book your Daily

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.