Engine

Iveco Daily All years 2.8 TDi 125hp (92kW) 290Nm remap

Standard this engine makes 125hp and 290Nm. Our Stage 1 file takes it to 156hp and 345Nm.

+31horsepower
+55newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
0428412616801,2001,6002,0002,400 RPM 0428412616801,4002,0002,600hp RPM
  • Standard 125hp
  • Remapped 156hp
Torque before and after
09318627937301,2001,6002,0002,400 RPM 09318627937301,4002,0002,600Nm RPM
  • Standard 290Nm
  • Remapped 345Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 2.8 TDi 125hp (92kW) 290Nm

FilePowerGainTorqueGainPrice
Standard125hpn/a290Nmn/an/a
Stage 1156hpup 31345Nmup 55ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 2.8 TDi 125hp (92kW) 290Nm

The Iveco Daily All years 2.8 TDi 125hp (92kW) 290Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Daily range, or everything we do for Iveco.

Book your Daily

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.