Engine

Iveco Stralis All years Cursor9 - 8.7 (EU6) 310hp (228kW) 1300Nm remap

Standard this engine makes 310hp and 1300Nm. Our Stage 1 file takes it to 375hp and 1680Nm.

+65horsepower
+380newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
010120330440501,2001,6002,0002,400 RPM 010120330440501,4002,0002,600hp RPM
  • Standard 310hp
  • Remapped 375hp
Torque before and after
04549071361181401,2001,6002,0002,400 RPM 04549071361181401,4002,0002,600Nm RPM
  • Standard 1300Nm
  • Remapped 1680Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the Cursor9 - 8.7 (EU6) 310hp (228kW) 1300Nm

FilePowerGainTorqueGainPrice
Standard310hpn/a1300Nmn/an/a
Stage 1375hpup 651680Nmup 380ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the Cursor9 - 8.7 (EU6) 310hp (228kW) 1300Nm

The Iveco Stralis All years Cursor9 - 8.7 (EU6) 310hp (228kW) 1300Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Stralis range, or everything we do for Iveco.

Book your Stralis

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.