Engine

Iveco Stralis All years S33 330hp (243kW) 1400Nm remap

Standard this engine makes 330hp and 1400Nm. Our Stage 1 file takes it to 376hp and 1598Nm.

+46horsepower
+198newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
010220330540601,5002,5003,5004,500 RPM 010220330540602,0003,5005,000hp RPM
  • Standard 330hp
  • Remapped 376hp
Torque before and after
04318631294172601,5002,5003,5004,500 RPM 04318631294172602,0003,5005,000Nm RPM
  • Standard 1400Nm
  • Remapped 1598Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the S33 330hp (243kW) 1400Nm

FilePowerGainTorqueGainPrice
Standard330hpn/a1400Nmn/an/a
Stage 1376hpup 461598Nmup 198ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the S33 330hp (243kW) 1400Nm

The Iveco Stralis All years S33 330hp (243kW) 1400Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Stralis range, or everything we do for Iveco.

Book your Stralis

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.