Engine

John Deere 6030 Series All years 6630 126hp (93kW) 530Nm remap

Standard this engine makes 126hp and 530Nm. Our Stage 1 file takes it to 156hp and 642Nm.

+30horsepower
+112newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
0428412616801,2001,6002,0002,400 RPM 0428412616801,4002,0002,600hp RPM
  • Standard 126hp
  • Remapped 156hp
Torque before and after
017334752069301,2001,6002,0002,400 RPM 017334752069301,4002,0002,600Nm RPM
  • Standard 530Nm
  • Remapped 642Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 6630 126hp (93kW) 530Nm

FilePowerGainTorqueGainPrice
Standard126hpn/a530Nmn/an/a
Stage 1156hpup 30642Nmup 112ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 6630 126hp (93kW) 530Nm

The John Deere 6030 Series All years 6630 126hp (93kW) 530Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full 6030 Series range, or everything we do for John Deere.

Book your 6030 Series

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.