McLaren Super Series 2015 onwards 650S Le Mans remap
Standard this engine makes 650hp and 678Nm. Our stage 2 file takes it to 720hp and 760Nm.
Where the power arrives
Power and torque through the rev range, on the stage 2 file.
- Standard 650hp
- Remapped 720hp
- Standard 678Nm
- Remapped 760Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 650S Le Mans
The McLaren Super Series 2015 onwards 650S Le Mans runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 2015 onwards, the full Super Series range, or everything we do for McLaren.
Other engines on this Super Series
2015 onwards cars.
Similar power, other makes
Cars running about the same standard output, for comparison.
Other Super Series generations
Book your Super Series
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.