Mercedes A W176 2012 to 2015 A220 remap
Standard this engine makes 184hp and 300Nm. Our STAGE 1 file takes it to 250hp and 400Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 184hp
- Remapped 250hp
- Standard 300Nm
- Remapped 400Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the A220
The Mercedes A W176 2012 to 2015 A220 runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the W176 2012 to 2015, the full A range, or everything we do for Mercedes.
Other engines on this A
W176 2012 to 2015 cars.
- 160 CDI90hp standardDiesel
- 180 CDI (1500cc)109hp standardDiesel
- 180 CDI (1800cc)109hp standardDiesel
- 200 CDI (1800cc)136hp standardDiesel
- 200 CDI (2100cc)136hp standardDiesel
- 200 CDI 4Matic136hp standardDiesel
- 220 CDI163hp standardDiesel
- 220 CDI170hp standardDiesel
- A180122hp standardPetrol
- A200156hp standardPetrol
- A250211hp standardPetrol
- 45 AMG360hp standardPetrol
Similar power, other makes
Cars running about the same standard output, for comparison.
Book your A
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.