Mitsubishi Fuso 2006 onwards 3.0 DDi STAGE 1
Takes the 3.0 DDi from 130hp to 160hp, and 300Nm to 360Nm.
Where the gain arrives
Standard against STAGE 1 through the rev range.
- Standard 130hp
- Remapped 160hp
- Standard 300Nm
- Remapped 360Nm
Standard against STAGE 1
| Measure | Standard | After | Gain |
|---|---|---|---|
| Power | 130hp | 160hp | up 30 |
| Torque | 300Nm | 360Nm | up 60 |
Other files for this engine
All written for the 3.0 DDi specifically.
What STAGE 1 involves
Stage 1 is for a standard car with nothing fitted. We read the original file off the ECU, write a calibration developed for the 3.0 DDi, then road or rolling road test it before handing the car back. Nothing is added and nothing is removed, so it looks and services exactly as it did.
It takes most of a day. We keep your original file, so it can go back to standard at any point. Figures here are for a healthy 3.0 DDi, and we check the car over before writing to it.
See the full 3.0 DDi page for every file and figure, the other engines on this Fuso, or all Mitsubishi remapping.
Other engines on this Fuso
Book your Fuso STAGE 1
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.