Opel Insignia 2009 to 2013 2.0 T remap
Standard this engine makes 220hp and 350Nm. Our STAGE 1 file takes it to 295hp and 450Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 220hp
- Remapped 295hp
- Standard 350Nm
- Remapped 450Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 2.0 T
The Opel Insignia 2009 to 2013 2.0 T runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 2009 to 2013, the full Insignia range, or everything we do for Opel.
Other engines on this Insignia
2009 to 2013 cars.
- 2.0 CDTI110hp standardDiesel
- 2.0 CDTI130hp standardDiesel
- 2.0 CDTI160hp standardDiesel
- 2.0 CDTI190hp standardDiesel
- 2.0 CDTI 195hp standardDiesel
- 1.6i115hp standardPetrol
- 1.4 T120hp standardPetrol
- 1.4 T140hp standardPetrol
- 1.6 T180hp standardPetrol
- 2.0 T (Delco Injection)220hp standardPetrol
- 2.0 T250hp standardPetrol
- 2.8 T260hp standardPetrol
- GT 2.0T264hp standardPetrol
- 2.8 T OPC325hp standardPetrol
Similar power, other makes
Cars running about the same standard output, for comparison.
Other Insignia generations
Book your Insignia
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.