Peugeot RCZ Ph1 2010 to 2013 1.6 THP remap
Standard this engine makes 156hp and 240Nm. Our STAGE 1 file takes it to 190hp and 300Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 156hp
- Remapped 190hp
- Standard 240Nm
- Remapped 300Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 1.6 THP
The Peugeot RCZ Ph1 2010 to 2013 1.6 THP runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the Ph1 2010 to 2013, the full RCZ range, or everything we do for Peugeot.
Other engines on this RCZ
Ph1 2010 to 2013 cars.
Similar power, other makes
Cars running about the same standard output, for comparison.
Other RCZ generations
Book your RCZ
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.