Engine

Steyr 6000serie All years 6125 125hp (92kW) 566Nm remap

Standard this engine makes 125hp and 566Nm. Our Stage 1 file takes it to 148hp and 654Nm.

+23horsepower

+88newton metres

1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after

Standard 125hp
Remapped 148hp

Torque before and after

Standard 566Nm
Remapped 654Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Stage 1148hpup 23654Nmup 88

Every figure for the 6125 125hp (92kW) 566Nm

File	Power	Gain	Torque	Gain	Price
Standard	125hp	n/a	566Nm	n/a	n/a
Stage 1	148hp	up 23	654Nm	up 88	ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 6125 125hp (92kW) 566Nm

The Steyr 6000serie All years 6125 125hp (92kW) 566Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full 6000serie range, or everything we do for Steyr.

Other engines on this 6000serie

All years cars.

Book your 6000serie

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.

Call 0121 238 8663 Ask a question