Engine

Steyr 6000serie All years 6155 CVT 156hp (115kW) 660Nm remap

Standard this engine makes 156hp and 660Nm. Our Stage 1 file takes it to 192hp and 786Nm.

+36horsepower
+126newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
05210415620701,2001,6002,0002,400 RPM 05210415620701,4002,0002,600hp RPM
  • Standard 156hp
  • Remapped 192hp
Torque before and after
021242463784901,2001,6002,0002,400 RPM 021242463784901,4002,0002,600Nm RPM
  • Standard 660Nm
  • Remapped 786Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 6155 CVT 156hp (115kW) 660Nm

FilePowerGainTorqueGainPrice
Standard156hpn/a660Nmn/an/a
Stage 1192hpup 36786Nmup 126ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 6155 CVT 156hp (115kW) 660Nm

The Steyr 6000serie All years 6155 CVT 156hp (115kW) 660Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full 6000serie range, or everything we do for Steyr.

Book your 6000serie

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.